Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

Wireless

JiZh_4619191
New Contributor II

Hi,

I configured a cyw20719b2 pin to falling edge interrupt, and found that the interrupt response time is 59 microseconds.

Is there and method to make the interrupt response time as short as possible?

 

Best regards,

Jian

0 Likes
1 Solution
Owen_Zhang123
Moderator
Moderator

The mcu uses event callback to handle the interrupt. It is normal for your test as the GPIO may also take some time. 

View solution in original post

0 Likes
3 Replies
Owen_Zhang123
Moderator
Moderator

How did you test the response time?

What do you use the interrupt for?

0 Likes
JiZh_4619191
New Contributor II

Hi,

1) At the beginning of Interrupt Service Routine(ISR), a wiced_hal_gpio_set_pin_output() set a GPIO high, at the end of ISR, a wiced_hal_gpio_set_pin_output() set the same GPIO low. And read the response time from a oscilloscope.

2)I would like to receive data from a peripheral chip.

0 Likes
Owen_Zhang123
Moderator
Moderator

The mcu uses event callback to handle the interrupt. It is normal for your test as the GPIO may also take some time. 

View solution in original post

0 Likes