- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, could you help me with the information of the CYBT-213043-Mesh board on how to program it through J-Link?
Solved! Go to Solution.
- Labels:
-
ispn:40214:1:0
-
l1:314:1:0
-
Wireless
- Tags:
- mesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
SWD interface is supported bty these devices for source code level debugging. For that you can use below pins. It is defined in spar_util.h. (SETUP_APP_FOR_DEBUG_IF_DEBUG_ENABLED)
Debugger Board (meshKits)
Pin-1 <--> VDD
Pin-7 <--> P13(SWDIO)
Pin-9 <--> P12(SWDCK)
Pin-20 <--> GND
Firmware download are done through the HCI UART lines.
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I would suggest you to use the Modustoolbox and tools such as chipload to download the firmware to CYBT-213043-MESH.
https://www.cypress.com/products/modustoolbox
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, good afternoon, could you tell me which pins are used to connect the j-link of the CYBT-213043-MESH board.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
SWD interface is supported bty these devices for source code level debugging. For that you can use below pins. It is defined in spar_util.h. (SETUP_APP_FOR_DEBUG_IF_DEBUG_ENABLED)
Debugger Board (meshKits)
Pin-1 <--> VDD
Pin-7 <--> P13(SWDIO)
Pin-9 <--> P12(SWDCK)
Pin-20 <--> GND
Firmware download are done through the HCI UART lines.
Thanks,
-Dheeraj