- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We finally got the successfully download our code into QQFN package after we added "recovery" button.
We have our own evaluation board - without the eLNA/ePA. Our code works on factory evaluation board.
We are porting the same code on QFN package. We do not observe any BLE transmit or heartbeat on the smartphone scanner. Is this because the code is programmed for external Amplifier? Or we have to change something in the code to enable internal Amplifier?
Solved! Go to Solution.
- Labels:
-
PSoC 4 MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nilesh - please see attached for the schematics of the CYW920721M2EVK-01 eval kit.
Dilli
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I guess we don't have to change anything to enable the PA. but we have to configure the interface for the PA if you are using. Check wiced_hal_epa_configure()
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you got it.
-Nilesh