- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
how to compile for raspberrypi compute module?
for yocto or raspbian anything will be helpful
Solved! Go to Solution.
- Tags:
- 43455
- raspberrypi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The wifi driver will work like any other network driver that you have for the compute module. Have you tried compiling the fmac driver and insmoded it into the system.
Could you attach a error log if you are facing any issue while insmoding the fmac driver for the kernel that you are using?
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I tried like that for raspberrypi by using this kernel
https://www.raspberrypi.org/documentation/linux/kernel/building.md
but its telling kernel is not configured with backports. I tried configuring kernel with backports but its not successful.
which version of backports to use with this kernel?
will Murata 1mw module directly work with raspbian?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
What is the kernel version that you are using ? <uname -a>
what is the specific error that you are getting.
Do you have an IO board for the compute module? Is the firmware for 1mw present in /lib/frimware/brcm/.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Kernel version i am using is 4.19.66-v7+
in /lib/firmware/brcm/ ,i found
brcmfmac43455-sdio.bin
brcmfmac43455-sdio.clm_blob
brcmfmac43455-sdio.txt
I have IO board for compute module,when i started compiling module for 1mw module by using backports ,raspbian kernel is not configured with backports,later i found that in forums they are using module directly.
So does 1mw module directly works with computemodule in raspbian?
I am also creating yocto image ,even in that kernel backports is not there.How to compile for that?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The wifi driver will work like any other network driver that you have for the compute module. Have you tried compiling the fmac driver and insmoded it into the system.
Could you attach a error log if you are facing any issue while insmoding the fmac driver for the kernel that you are using?
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, we are getting this error.
SDIO frequency set at 50MH
Do we have to configure pins on uSD-M2 module?
we pulled up WL_REG_ON pin with 1k resistor