- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi pkkr
I'm debugging a problem of 88335.
I can modify AP WMM parameters (hostapd.conf)as bellow:
wmm_enabled=1
#
# WMM-PS Unscheduled Automatic Power Save Delivery [U-APSD]
# Enable this flag if U-APSD supported outside hostapd (eg., Firmware/driver)
#uapsd_advertisement_enabled=1
#
# Low priority / AC_BK = background
wmm_ac_bk_cwmin=3
wmm_ac_bk_cwmax=6
wmm_ac_bk_aifs=7
wmm_ac_bk_txop_limit=0
wmm_ac_bk_acm=0
How can I modify wmm priority with wpa_supplicant.conf when using 88335 as a station ?
Thanks.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Couldn't find any parameters in wpa_supplicant.conf to change the WMM priority. You could try the wpa_cli command
wmm_ac_addts <uplink/downlink/bidi> <tsid=0..7> <up=0..7> [nominal_msdu_size=#] [mean_data_rate=#] [min_phy_rate=#] [sba=#] [fixed_nominal_msdu]:To add WMM AC traffic stream.
The up(user priority) flag in it could be used to set the priority for the traffic stream added.
Other cli commands that you could try out are:
wmm_ac_delts <tsid>: delete WMM-AC traffic stream
wmm_ac_status : show status for Wireless Multi-Media Admission-Control
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Couldn't find any parameters in wpa_supplicant.conf to change the WMM priority. You could try the wpa_cli command
wmm_ac_addts <uplink/downlink/bidi> <tsid=0..7> <up=0..7> [nominal_msdu_size=#] [mean_data_rate=#] [min_phy_rate=#] [sba=#] [fixed_nominal_msdu]:To add WMM AC traffic stream.
The up(user priority) flag in it could be used to set the priority for the traffic stream added.
Other cli commands that you could try out are:
wmm_ac_delts <tsid>: delete WMM-AC traffic stream
wmm_ac_status : show status for Wireless Multi-Media Admission-Control