Aug 01, 2019
03:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2019
03:15 AM
hello:
I am testing the receiving sensitivity in non-signaling mode. How to calculate the bit error rate according to the returned information,as follow:
I think there is no problem with the test method I used. I just don't know how to convert it,thanks!
Solved! Go to Solution.
1 Solution
Aug 01, 2019
10:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2019
10:42 PM
According the packet type generated from Litepoint or other devices, check the pktengrxducast , pktengrxdmcast value , it must be tested in a shielding room, before test the value needs a reset to zero.
1 Reply
Aug 01, 2019
10:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2019
10:42 PM
According the packet type generated from Litepoint or other devices, check the pktengrxducast , pktengrxdmcast value , it must be tested in a shielding room, before test the value needs a reset to zero.