Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

Wi-Fi Bluetooth for Linux

ew
New Contributor II

Hi

I'm using your latests brcmfmac firmware (released 15.Jan.2020),

with a Murata 1MW module with 43455 chipset.

The platform I'm using is a iMX6 with Linux kernel 5.4 & hostapd version 2.9.

WPA2 is working fine already, but for WPA3 I'm missing an example

hostap.conf, which was succesfuly tested by Cypress !

Please provide a good example of this configuration file,

tested with an iPhone with current iOS 13, ideally 🙂

Thanks

ew

1 Solution
VinayakS_26
Moderator
Moderator

Hi,

PFA a sample hostapd.conf file with wpa3 support.

Make sure to enable CONFIG_SAE=y aand CONFIG_IEEE80211N=y in your .config file while building the hostapd source.

Regards

View solution in original post

0 Likes
2 Replies
VinayakS_26
Moderator
Moderator

Hi,

PFA a sample hostapd.conf file with wpa3 support.

Make sure to enable CONFIG_SAE=y aand CONFIG_IEEE80211N=y in your .config file while building the hostapd source.

Regards

View solution in original post

0 Likes
yasa_4608926
Contributor II

Hi,

I am also using it. (cypress-fmac-v4.14.77-2020_0115.zip)

The following parameters are set in hostapd.conf for WPA3, and it's working fine.

ieee80211w=2

wpa_key_mgmt=SAE

rsn_pairwise=CCMP

sae_password=<password>

Best regards,

Yasa