- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Team,
I’m using CYM43455 module with the customized board and Jetson Xavier NX SoM.
When I try to do hciattach command, first few times the command is not working.
$ sudo hciattach /dev/ttyTHS0 bcm43xx
It gives the below errors.
bcm43xx_init
Failed to reset chip, invalid HCI event
Can't initialize device: Success
bcm43xx_init
Initialization timed out
Tried increasing timeout using argument -t in hciattach too.Still Initialization times out.
When the hciattach command is given repeatedly, after few attempt, the command works.
$ sudo hciattach /dev/ttyTHS0 bcm43xx
bcm43xx_init
Set Controller UART speed to 3000000 bit/s
Device setup complete
Can you please help in finding the cause of this issue?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi BaM_4840156,
Please check the UART you are using. Please refer following threads with similar issue:
Murata 1MW with IMX6UL on Linux, Blueooth Initiliastion timing out
CYW43438 on RPI, not able to communicate over UART to enable BT
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi BaM_4840156,
Please check the UART you are using. Please refer following threads with similar issue:
Murata 1MW with IMX6UL on Linux, Blueooth Initiliastion timing out
CYW43438 on RPI, not able to communicate over UART to enable BT