Im using the BCM943362WCD4 (rev P200) on a BCM9WCD1EVAL1 board, rev P100. My host is a Mac. The debugger uses the FTDI USB-serial converter on the EVAL1 board. I follow the QSG instructions to debug an app on the device, and it all works, up to section 4.3, step 8: "To stop debugging, click the square red stop button in the Debug tab". I do this, and perhaps debugging stops, but I cant build, run and debug my app again. The IDE hangs, and I have to force quit it.
Is there some magic sequence of operations I have to make in order to go through the build/run/debug cycle without force-quitting Eclipse?
