Oct 02, 2015
04:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 02, 2015
04:10 AM
I understand the WICED SDK provides OTA for firmware upgrades. However, the STM 32 bootloader supports the DFU protocol (Device Firmware Upgrade) but it is not clear how to use it with the WICED.
I am wondering if I can get some directions and advise on how to use DFU in a WICED design. It seems very important not only in development, as DFU is a widely used protocol with host software available for a variety of OS.
Thanks.
Labels
1 Reply
Anonymous
Not applicable
Oct 06, 2015
02:19 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 06, 2015
02:19 AM
I have used SN8205(STM32F2 + BCM43362), it can programmed using STM32 DfuSe when you pull boot high.