cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Studio Wi-Fi Combo

MaGr_2160016
New Contributor II

I understand the WICED SDK provides OTA for firmware upgrades. However, the STM 32 bootloader supports the DFU protocol (Device Firmware Upgrade) but it is not clear how to use it with the WICED.

I am wondering if I can get some directions and advise on how to use DFU in a WICED design. It seems very important not only in development, as DFU is a widely used protocol with host software available for a variety of OS.

Thanks.

0 Likes
1 Reply
Anonymous
Not applicable

I have used SN8205(STM32F2 + BCM43362), it can programmed using STM32 DfuSe when you pull boot high.

0 Likes