- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This may be a dumb question but I couldn't find the answer in the documentation. I am using WICED Studio & I have 2 CYW920719Q40EVB-01 boards that are connected via separate USB cords to the same computer that I would like to download & run different programs on using the WICED Studio IDE.
My question is: Is there a way to configure Make Targets in WICED Studio such that different USB/Serial ports are specified as part of the target instructions? My goal is to be able to develop different applications in WICED that I can quickly program to either board without having to plug & unplug wires (if possible). Thank you in advance!
-Kendall
Solved! Go to Solution.
- Labels:
-
WICED Studio
-
Wifi+Bluetooth
-
Windows
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1. Find the HCI UART Port in your device manager:
2. In the make target, add UART=COMx, such as "demo.hello_sensor-CYW920719Q40EVB_01 download UART=COM18"
Then you can program the specified target.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1. Find the HCI UART Port in your device manager:
2. In the make target, add UART=COMx, such as "demo.hello_sensor-CYW920719Q40EVB_01 download UART=COM18"
Then you can program the specified target.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Exactly what I was looking for. Thank you so much!