- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I managed to create a simple USB CDM-ACM project that uses the USBX driver. If I understand correctly, USBX is dependent on ThreadX.
Is it possible to use USBX with FreeRTOS?
If not, is there other alternative driver that works with FreeRTOS?
Currently I am using a development board with BCM43907 chip.
Thanks in advance.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
USBX is the only supported USB stack/driver in current Wiced SDK.
Kindly check in FreeRTOS community for the supported stack. I hope this thread helps [RTOS Support] USB Driver and USB Stack Support.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Christian,
Good to hear that you were able to create CDC-ACM project! But USBX is not supported with FreeRTOS.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there other alternative driver that works with FreeRTOS?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
USBX is the only supported USB stack/driver in current Wiced SDK.
Kindly check in FreeRTOS community for the supported stack. I hope this thread helps [RTOS Support] USB Driver and USB Stack Support.