Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I have purchased SN8205 module and I can successfully download Scan application into SN8205 module using JTAG Olimex programmer as well as SN8200 Evolution board. I am using Wiced SDK version 2.4.1. I am using below make target.
1) JTAG Olimex programmer:
- snip.scan-SN8205x-debug JTAG=Olimex_ARM-USB-TINY-H download run
- snip.scan-SN8205x JTAG=Olimex_ARM-USB-TINY-H download run
2) SN8200 Evolution Board
- snip.scan-SN8205x download run
Now problem is scan application couldn't start to execute and also couldn't receive debug prints over UART. By debugging this issue I found that program is stuck in "Wiced/platform/common/ARM_cortex_M3/STM32F2xx/stm32fxx_platform.c" file with below line.