Feb 01, 2021
07:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 01, 2021
07:01 AM
Hello.
I want to start WiFi as AP with a specific SSID.
My SSID has to be "MyProduct_SNXXXX" where "XXXX" is the serial number of my product
and has to be stored in some non volatile memory (FLASH, EEPROM, uSD).
Using "wifi_config_dct.h" macro is not a good idea.
Solved! Go to Solution.
Labels
- Labels:
-
WICED Studio Wi-Fi Combo
1 Solution
Feb 01, 2021
11:33 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 01, 2021
11:33 PM
Take a look at /43xxx_Wi-Fi/apps/snip/dct_read_write
You can start your application, then set the serial number of whatever that is needed in the WIFI DCT section and then start the AP.
This should solve the requirement that is needed.
5 Replies