Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I am trying to run the snip scan as per the Quick Start Guide in the debugger.
The debugger comes up as expected with the first line of code - exactly as shown in the QSG. The only exception is that in the Console messages I get
stepi ignored. GDB will now fetch the register state from the target.
When I try to get the program to run (F8 - takes 2 continues to run) (having already set a breakpoint in the scan.c code) it stops at the end of for the vPortYieldFromISR routing in port.c. When i try to get the program to repeatedly stops here never advancing to the breakpoint in scan.c
Without a breakpoint set the code executes without stopping. I have tried other code snips with the same results
I think the configuration of the debugger is correct but the directions listed in the QSG seem to be for an earlier version and their are some minor differences as I installed the software