- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm using a Windows 7 VM installed using VMWare Fusion 6.0.2 on Mac OSX 10.9.1. I get the following error when I try to build snip.scan-BCM943362WCD4 download run:
Downloading Bootloader ...
"**** OpenOCD failed - ensure you have installed the driver from the drivers directory, and that the debugger is not running **** In Linux this may be due to USB access permissions. In a virtual machine it may be due to USB passthrough settings. Check in the task list that another OpenOCD process is not running. Check that you have the correct target and JTAG device plugged in. ****"
Downloading Application ...
"**** OpenOCD failed - ensure you have installed the driver from the drivers directory, and that the debugger is not running **** In Linux this may be due to USB access permissions. In a virtual machine it may be due to USB passthrough settings. Check in the task list that another OpenOCD process is not running. Check that you have the correct target and JTAG device plugged in. ****"
Downloading DCT ...
"**** OpenOCD failed - ensure you have installed the driver from the drivers directory, and that the debugger is not running **** In Linux this may be due to USB access permissions. In a virtual machine it may be due to USB passthrough settings. Check in the task list that another OpenOCD process is not running. Check that you have the correct target and JTAG device plugged in. ****"
Resetting target
Makefile:227: recipe for target 'run' failed
make: *** [run] Error 1
I'm using Wiced-SDK-2.4.0. Any hints on how to get around this problem? It is not clear what USB passthrough settings if any are the issue here. I've had no problems interfacing with other boards using USB and this very same VM set up. Any help is greatly appreciated.
Regards,
Arvind