- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I read datasheet (Document Number: 002-14829 Rev. *L) at page 38
PWM_0 seems to be an output
Also on MURATA datasheet (SP-UZ1GC-S) at page 10
On demo board PWM_0 is used as input (USD_DETECT)
And in the firmware WICED I read on platform.h
|---------------+-----+--------------+-----+-------------------------+--------------------------+--------+--------------+-------------------------------|------------------|
| WICED_GPIO_13 | 185 | PWM_0 | C10 | PWM_0 | PWM_0 | N/C | PWM, GPIO | uSD Connector/Slot Detect | |
|---------------+-----+--------------+-----+-------------------------+--------------------------+--------+--------------+-------------------------------|------------------|
And in the EVM PWM_0 can be configured as input and it works correctly.
Solved! Go to Solution.
- Labels:
-
WICED Studio Wi-Fi Combo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for enriching the community with your valuable feedback.
We will investigate this.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for enriching the community with your valuable feedback.
We will investigate this.