- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm using the Wi-Fi board (BCM943362WCD4) WICED.
KL25Z of Freescale is sending UART in the sensor information.
I would like to display on the server to receive data from the UART, but it does not work well.
I have confirmed that WICED received data from the UART by the terminal software.
I have attempted the synthesis of UART.c and AP_content.c now.
Apps / wwd / appliance / AP_content.c
Apps / snip / uart / uart.c
Can I Change of where the program?
Also, What are the ways to achieve such a program?
I am Japanese.
Operating environment
windows7 32bit
wiced IDE 2.4.1
Solved! Go to Solution.
- Labels:
-
UART
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Are you trying to display messages received and sent over the UART? if so, please take a look at UART Setup and Uart Messages Over Webpage.
Are you having trouble receiving or sending UART messages sending it to the external server?
Thanks,
Seyhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Are you trying to display messages received and sent over the UART? if so, please take a look at UART Setup and Uart Messages Over Webpage.
Are you having trouble receiving or sending UART messages sending it to the external server?
Thanks,
Seyhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,Seyhan
Thank you for your polite answer and kindness.
I'll try your advice.
yuta_ueno