Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I am using Murata's SN8200x wifi module and WICED-SDK-2.4.0. The module acts as STA client. I need to configure SSID and password of my wireless router in module on the run without hardcoding them in the code. Also I should be able to change them as required without reflashing.
I am aware there is a wiced_configure_device() function which make module as AP initially to allow us to set the ssid and password.
But this seems to be inefficient. If there are many modules, connecting to each module and setting the details is tiresome.
If you type help at the WiConnect prompt followed by the action you will find WiConnect has a built in help feature.
> help wps
Usage : wps [<PIN code>/<\0>] [timeout in seconds] [stop]
Brief : Runs Wi-Fi Protected Setup (WPS) to enable the wlan interface to connect with an Access Point. PIN and push-button (PBC) modes are supported, PBC mode is default. To specify a timeout for PBC mode, use \0 as the first argument