- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can we interface CYW43455 VIO to 1.8V to run SDIO at 1.8V? Yes, then how to configure SDIO for 1.8V operation at default starting from initialization?
Using Murata Module - LBEE5HY1MW-230
Solved! Go to Solution.
- Tags:
- murata
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello:
So your concerns are :
a. 3.3v transfer to 1.8V , SDIO emulation will fail if we set a wrong voltage ?
b. don't know how to set VDDIO on the device.
My answer are here:
1. We only can set one voltage of IO, we will not change mode dynamically since it is a hardware strap pin.
2. if final IO =1.8V, set the device IO to 1.8v.
3. if you really have concerns, do not pull wl_REG_ON pin before SDIO interface is stable.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello:
would you please check below setting in the module ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
This not what I meant.
I need to understand how to make SDIO work directly at 1.8V when you are not using 3.3V. What are the configs and settings do I take care in driver or software?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, I didn't find any special setting for 1.8V IO setting in the code.
Did you meet problems when trying to set the interface to 1.8V IO voltage ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Software team is concerned on initial requirement of 3.3V for initialization of SDIO before it switches to 1.8V. Which mode do you select to configure this in for initialization (first transaction) on 1.8V?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello:
So your concerns are :
a. 3.3v transfer to 1.8V , SDIO emulation will fail if we set a wrong voltage ?
b. don't know how to set VDDIO on the device.
My answer are here:
1. We only can set one voltage of IO, we will not change mode dynamically since it is a hardware strap pin.
2. if final IO =1.8V, set the device IO to 1.8v.
3. if you really have concerns, do not pull wl_REG_ON pin before SDIO interface is stable.