cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Studio Wi-Fi Combo

YoLi_2201496
New Contributor

Hi,

     When I try to use J-Link Debugger(SEGGER - The Embedded Experts for RTOS and Middleware, Debug Probes and Production Programmers - J-L... ) to attatch the running board with the elf files provided under eclipse_debug.

     It seems the  symbol table is not corret, I can't get the corret call stack.http://cn.bing.com/dict/search?q=symbol&FORM=BDVSP6&mkt=zh-cn

     Has any body ever  try to debug BCM943362WCD4 using this tool?

0 Likes
Reply
1 Solution
RaktimR_11
Moderator
Moderator

Please follow this Downloading and debugging CYW43907 using Jlink Segger  article to download through JLink. As the platform you mentioned already have a J-Link header, you can go ahead and plug yout Jlink device and follow the rest of the steps.

View solution in original post

3 Replies
RaktimR_11
Moderator
Moderator

Please follow this Downloading and debugging CYW43907 using Jlink Segger  article to download through JLink. As the platform you mentioned already have a J-Link header, you can go ahead and plug yout Jlink device and follow the rest of the steps.

View solution in original post

MaR_3698711
New Contributor

Hi

i'am using Murata Type1LD custom based board i followed the above steps but it did not work for me

please can you help me regarding this

0 Likes
Reply
RaktimR_11
Moderator
Moderator

That article is only valid for CYW43907, not for ST host based platforms like 1LD. You can follow the steps mentioned in OpenOCD -WICED​ to download and debug 1LD based custom platform (Please check the comments section as well for modifications required in jlink.cfg).

While downloading, you might need to use Zadig to change the default driver of J-Link to libusbK and while debugging you need to switch back to J-Link driver.