Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
OK
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

WICED Studio Wi-Fi Combo

Anonymous
Not applicable
‎Sep 18, 2013 03:36 AM

Can I get signal strength of each packet under monitor mode?

Jump to solution
We have 3 questions in our development.

1. Can I get signal strength of each packet under monitor mode? Could you give us an example?

2. Can Monitor Mode work with STA Mode together at the same time?

3. If we dont set any filter in monitor mode, the chip will dead after a little while, why? Can we solve this problem?

Thank you very much!
Labels
0 Likes
Reply
1 Solution
Anonymous
Not applicable
‎Sep 24, 2013 10:59 PM

Re: Can I get signal strength of each packet under monitor mode?

Jump to solution
1. No you cannot get signal strength of each packet under monitor mode.

2. No. This is not supported.

3. The total number of packets on the medium far exceed the bandwidth of the WLAN device, the bandwidth of bus between the WLAN device and the host, and the packet processing resources available on the host. We currently do not have a solution that can survive the running monitor mode without filters.

View solution in original post

0 Likes
Reply
2 Replies
Anonymous
Not applicable
‎Sep 24, 2013 10:59 PM

Re: Can I get signal strength of each packet under monitor mode?

Jump to solution
1. No you cannot get signal strength of each packet under monitor mode.

2. No. This is not supported.

3. The total number of packets on the medium far exceed the bandwidth of the WLAN device, the bandwidth of bus between the WLAN device and the host, and the packet processing resources available on the host. We currently do not have a solution that can survive the running monitor mode without filters.

View solution in original post

0 Likes
Reply
Anonymous
Not applicable
‎Sep 26, 2013 09:17 AM

Re: Can I get signal strength of each packet under monitor mode?

Jump to solution 
1. No you cannot get signal strength of each packet under monitor mode.
2. No. This is not supported.
3. The total number of packets on the medium far exceed the bandwidth of the WLAN device, the bandwidth of bus between the WLAN device and the host, and the packet processing resources available on the host. We currently do not have a solution that can survive the running monitor mode without filters.

nikvh, Thank you very much for your reply!

Signal strength under monitor mode is very important in our project. Is there any possible way to get these information? By BD or something else?
0 Likes
Reply