Anonymous
Not applicable
Jan 26, 2018
01:11 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 26, 2018
01:11 PM
I added the new make files to run the snips as mentioned in the introduction video.
Then when I tried to run the "snip.gpio", it said that
"MAKEFILE MAKECMDGOALS = snip.gpio-CYW943907AEVAL1F download run OTA2_SUPPORT is disabled
make: *** Access is denied. "
I don't know what to do for this error. Please help me.
Solved! Go to Solution.
1 Solution
Feb 19, 2018
04:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 19, 2018
04:05 AM
Kindly check the device manager of your laptop and see if the board appears there. If the drivers are installed properly, the device manager should look like this:
In case the drivers are not installed, install it from WICED-Studio-6.0.1\Drivers\Windows\uart.
1 Reply