cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Studio Wi-Fi Combo

Anonymous
Not applicable

I added the new make files to run the snips as mentioned in the introduction video.

Then when I tried to run the "snip.gpio", it said that

"MAKEFILE MAKECMDGOALS = snip.gpio-CYW943907AEVAL1F download run OTA2_SUPPORT is disabled

make: *** Access is denied. "

I don't know what to do for this error. Please help me.

0 Likes
1 Solution
PriyaM_16
Moderator
Moderator

Kindly check the device manager of your laptop and see if the board appears there. If the drivers are installed properly, the device manager should look like this:

pastedImage_1.png

In case the drivers are not installed, install it from WICED-Studio-6.0.1\Drivers\Windows\uart.

View solution in original post

0 Likes
1 Reply
PriyaM_16
Moderator
Moderator

Kindly check the device manager of your laptop and see if the board appears there. If the drivers are installed properly, the device manager should look like this:

pastedImage_1.png

In case the drivers are not installed, install it from WICED-Studio-6.0.1\Drivers\Windows\uart.

View solution in original post

0 Likes