cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Studio Wi-Fi Combo

New Contributor

Hi,

I wanted to use some of the peripherals which are under the wiced.platform.MCU.STM32F4xx.peripherals.libraries.src like

stm32f4xx_ltdc.c

stm32f4xx_i2c.c

The platform is : CYW94343WWCD1_EVB-FreeRTOS-LwIP

If I use the following command for making target:

snip.bluetooth.ble_hello_sensor-CYW94343WWCD1_EVB-FreeRTOS-LwIP

Are the peripherals driver getting build?

If not which command I need to set to ensure the peripheral drivers are getting build

Thanks

0 Likes
Reply
1 Solution
Moderator
Moderator

KaHi_4747291 You can check if a peripheral or any other driver/peripheral is built or not by checking the respective application in the build directory. In this case, if you want the /43xxx_Wi-Fi/WICED/platform/MCU/STM32F4xx/peripherals/libraries/src/stm32f4xx_ltdc.c to get compiled you need to enable the ltdc clock as mentioned in the comments at the beginning of the file.

View solution in original post

1 Reply
Moderator
Moderator

KaHi_4747291 You can check if a peripheral or any other driver/peripheral is built or not by checking the respective application in the build directory. In this case, if you want the /43xxx_Wi-Fi/WICED/platform/MCU/STM32F4xx/peripherals/libraries/src/stm32f4xx_ltdc.c to get compiled you need to enable the ltdc clock as mentioned in the comments at the beginning of the file.

View solution in original post