- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have this Bridge_1 board but got "OpenOCD failed" error when downloading the appliance sample. It seems that I am missing FTDI driver and someone in the forum mentioned about a batch file for installation. Could anyone share the link to that batch file? Or is there any other solution to this?
Solved! Go to Solution.
- Labels:
-
SPI
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vincent,
Please check that the driver for the evaluation board had been installed from .../Drivers/BCM9WCD1EVAL1_Drivers/.
Thanks,
Seyhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vincent,
Could you please share the .../build/openocd_log.txt log file?
Thanks,
Seyhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vincent,
Please check that the driver for the evaluation board had been installed from .../Drivers/BCM9WCD1EVAL1_Drivers/.
Thanks,
Seyhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Also, using section "3.1.3 Verifying Driver Installation" in .../Doc/WICED-QSG202-R.pdf, please verify driver installation.
If all fails, please share the your evaluation board USB device vendor and product ids from Device Manager.
Thanks,
Seyhan