- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
my usb serial configuration utility can't connect to CYBT-413055- EVAL (with CY7C65215A on it)
for a standallone :
CY7C65215A it work 's , but later i need to connect to Bt-chip cybt-413061.
Is there a solution , to use gpio 's from
CY7C65215A on the Cy_413055-Eval-board
Solved! Go to Solution.
- Tags:
- bt-connection
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
May I know what is the the my usb serial configuration utility you are using? Is this tool works on the CYBT-413055- EVAL kit using the default kit configuration?
Are you using CYBT-413055- EVAL kit? or Performing the test on the custom board which you have created using CYBT-413055- 02 module as per the schematics attached?
Please check the reference schematics of the from https://www.cypress.com/documentation/datasheets/cybt-413055-02cybt-413061-02-ez-bt-wiced-module . As per the schematics two two UART channels are routed through SW4 and SW5. I hope, you can try to turn the SW5 off states and route those UART pins to your GNSS module to create similar test setup as you described in the attached schematics.
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
May I know what is the the my usb serial configuration utility you are using? Is this tool works on the CYBT-413055- EVAL kit using the default kit configuration?
Are you using CYBT-413055- EVAL kit? or Performing the test on the custom board which you have created using CYBT-413055- 02 module as per the schematics attached?
Please check the reference schematics of the from https://www.cypress.com/documentation/datasheets/cybt-413055-02cybt-413061-02-ez-bt-wiced-module . As per the schematics two two UART channels are routed through SW4 and SW5. I hope, you can try to turn the SW5 off states and route those UART pins to your GNSS module to create similar test setup as you described in the attached schematics.
Thanks,
-Dheeraj