- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello,
i am using CYBT-413034-02 and CYBT-413055 ble chips and i am programming this modules using evaluation board of HCI uart and PUART through USB serial.
can i able to configure the HCI uart as normal for flashing an external memory after programming the module. i only need rx and tx for the flashing external serial flash.
also i need to use PUART for the trace.
i dont know if it possible , if there is please let me know.
thank you,
regards,
danny.MichaelF_56SheetalJ_96broadcomwiced-adminDaZh_2976111
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
If you are planning to program the cypress chip using an external MCU, you can refer WICED-HCI-Control-Protocol.pdf This document will show us how a host microcontroller unit (MCU) can communicate with a Cypress WICED device via HCI UART.
You can refer the lab manual examples (Chapter5) to understand how HCI modes and communications are coded.
Please check wiced_transport.h for related transport utility APIs and descriptions.
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Sorry, I couldn't understand your exact requirement.
Generally we will be able use HCI UART for programming and PUART for debug traces. You can configure to reroute the debug traces to HCI UART as well (check wiced_debug_uart_types_t in wiced_bt_trace.h). In HCI UART two modes are there -WICED_TRANSPORT_UART_HCI_MODE and WICED_TRANSPORT_UART_RAW_MODE.
May I know which SDK are you using? And what exactly is your requirement?
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi,
my exact requirement is , i want to use HCI uart to flash a external serial flash using hci uart rx and tx.
how to send data in HCI uart rx and tx pins.
please provide an example code for how to send data and receive data using HCI uart rx and tx.
i am using wiced studio 6.0 and version of sdk is
WICED-SDK Version: Wiced_006.004.000.0061
DaZh_2976111MichaelF_56SheetalJ_96broadcomwiced-adminAnjanaM_61
thank you,
regards ,
danny
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
If you are planning to program the cypress chip using an external MCU, you can refer WICED-HCI-Control-Protocol.pdf This document will show us how a host microcontroller unit (MCU) can communicate with a Cypress WICED device via HCI UART.
You can refer the lab manual examples (Chapter5) to understand how HCI modes and communications are coded.
Please check wiced_transport.h for related transport utility APIs and descriptions.
Thanks,
-Dheeraj