cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Studio Bluetooth

New Contributor

Hello

1.

I was previously taught by the thread below how to use CYBT-343026-01 in HCI mode.

https://community.cypress.com/t5/WICED-Studio-Bluetooth/About-the-WICED-HCI-protocol/m-p/57884#M1051

When I used the Inquiry command to search for peripheral devices after booting in HCI mode, no Inquiry result was returned.

Do I need to make any other settings after booting?

(I can find multiple devices by running the Inquiry command in EZ-Serial mode.)

 

2.

I also found the description However you may need to program it initially with firmware / patches. In the thread below.

https://community.cypress.com/t5/WICED-Studio-Bluetooth/How-to-download-the-controller-firmware-of-C...

Also, does this have anything to do with the behavior in Question 1?

Isn't it possible to use standard HCI just by switching to HCI mode by operating SPI_MOSI and CTS at reset?

Is it possible to provide firmware / patches for Android?

 

Best Regards

Hayato

0 Likes
Reply
1 Solution
Moderator
Moderator

Duplicated with Solved: Initial settings when using HCI mode - Cypress Developer Community

The community had been experienced some problem(certain threads not published immediately) due to migration, sorry for the convenience.

Roy Liu

View solution in original post

0 Likes
Reply
1 Reply
Moderator
Moderator

Duplicated with Solved: Initial settings when using HCI mode - Cypress Developer Community

The community had been experienced some problem(certain threads not published immediately) due to migration, sorry for the convenience.

Roy Liu

View solution in original post

0 Likes
Reply