cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Studio Bluetooth

New Contributor

Hello!

     I want to send LMP_test_activate PDU from Master to Slave, is there any way?

     Is there a corresponding HCI command that can implemente this?

     Thanks!

0 Likes
Reply
1 Solution
Moderator
Moderator

I checked the bluetooth spec, there isn't such HCI command for the device to send LMP_test_active PDU. The LM layer is also not open to the customer.

View solution in original post

3 Replies
Moderator
Moderator

You may send HCI comand: Enable_Device_Under_Test_Mode. It is a HCI command and can support by the device.

New Contributor

     Thanks!

     I know this command. But my purpose is to control the local device to send LMP_test_activate PDU to the remote device. Is there any feasible way?

0 Likes
Reply
Moderator
Moderator

I checked the bluetooth spec, there isn't such HCI command for the device to send LMP_test_active PDU. The LM layer is also not open to the customer.

View solution in original post