- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
wiced_hal_puart_set_baudrate() is the only one api as am aware is available to config the PUART communication interface. Is there a way to configure the PUART to support customized baud rate and also even parity with stop bits.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi kishan_1448651,
Currently we only have wiced_hal_puart_set_baudrate() to configure PUART. There is no other way to customize the PUART.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi kishan_1448651,
Currently we only have wiced_hal_puart_set_baudrate() to configure PUART. There is no other way to customize the PUART.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok, does that also means it only supports standard baud rate or we can pass customized baud rate value.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can change the baud rate using the API mentioned above but you cannot change other parameters like parity bit.
Please refer this blog post: CYW20719 and CYW20735 Peripheral and HCI UARTs