cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Studio Bluetooth

Anonymous
Not applicable

We need to place the CYW20706 in Direct Test Mode (DTM) for BLE RF testing with an external protocol analyzer.  How is this done?

0 Likes
Reply
1 Solution
Anonymous
Not applicable

You are correct.

1) CYW20706 has HCI UART over which you can send HCI commands directly (be it for testing or other purposes).

2) You can use the MBT (Manufacturing Bluetooth Test) tool to send HCI commands to the device.

3) Yes, you can pull CTS low and use the 2-wire interface to send HCI commands.

View solution in original post

0 Likes
Reply
2 Replies
Anonymous
Not applicable

It appears as though the device starts up in DTM, although the Manufacturing Bluetooth Test Tool issues vendor-specific HCI commands as well, such as the continuous transmit test.

CTS is used for flow control. 

I wonder if it can simply be tied low, as Bluetooth test boxes do not use CTS.  2-wire interface only.

Anonymous
Not applicable

You are correct.

1) CYW20706 has HCI UART over which you can send HCI commands directly (be it for testing or other purposes).

2) You can use the MBT (Manufacturing Bluetooth Test) tool to send HCI commands to the device.

3) Yes, you can pull CTS low and use the 2-wire interface to send HCI commands.

View solution in original post

0 Likes
Reply