Jan 03, 2021
06:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 03, 2021
06:36 PM
hi Cypress:
when we use cyw20706 to receive the i2s smart voice, how to connect the hardware, there are some noise in I2S clk/dio,show as below; do you have any advice?
Solved! Go to Solution.
1 Solution
Jan 05, 2021
06:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 05, 2021
06:08 PM
It seems you missed the waveform. The I2S/PCM interface for CYW20706 is fixed.
If the CYW20706 act as a I2S slave, the clk is supplied by the master device. You may check the master side for the reason.
1 Reply
Jan 05, 2021
06:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 05, 2021
06:08 PM
It seems you missed the waveform. The I2S/PCM interface for CYW20706 is fixed.
If the CYW20706 act as a I2S slave, the clk is supplied by the master device. You may check the master side for the reason.