- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am having trouble on getting 40KB/s throughput from module to my laptop. According to this thread , by @Owen_Zhang123 ,the module is capable of having a throughput of 65KB/s. I would like to know the test configurations used during the said and would like to have my test configuration the same for my testing.
Thanks,
Solved! Go to Solution.
- Labels:
-
WICED Studio Bluetooth
- Tags:
- ez-serial
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
CYSPP/EZ-Serial doesn't have much configurable parameters. If your tests completed successfully without errors, then it's already the optimized speed you could probably get in your environment.
Please note that: BT/BLE uses back-off algorithm. Hence if the 2.4Ghz radio channels are busy in your environment, then you will observe relatively low test results.
Best regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
CYSPP/EZ-Serial doesn't have much configurable parameters. If your tests completed successfully without errors, then it's already the optimized speed you could probably get in your environment.
Please note that: BT/BLE uses back-off algorithm. Hence if the 2.4Ghz radio channels are busy in your environment, then you will observe relatively low test results.
Best regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Charles_Lai ,
My test wasn't successful as the throughput requirement which is at least 40kB/s was not satisfied with this module using EZ-serial. Hence I prefer repeating the same configuration performed by Cypress tech team to see if it helps. This evaluation is critical for our design.
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We are using teraterm on both side as the UART tool. Then transfer files from the module to laptop.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks @Owen_Zhang123 . Could you please let me know the baudrate of the module and how you measured the throughput. Thanks