[EZ-Serial Firmware for CYW2070x-based Modules] SSLP default settings

[KeTa_1341526]

Hello,

When the default setting of SSLP (system_set_sleep_parameters) is read by GSLP (system_get_sleep_parameters), L = 1 (Normal sleep when possible).

The User Guide states that L = 0 (Sleep disabled) is "factory default".

Is this the wrong User Guide?

https://www.cypress.com/file/452971/download

7.2.2.12 system_set_sleep_parameters (SSLP, ID=2/19)

Best regards,

Takahashi

[Charles_Lai]

Hi,

It might be changed in the actual factory default settings. But you are referring to the correct and only user guide of EZ-Serial.

Best regards

[KeTa_1341526]

Hi,

The User Guide [10.1 Factory Default Settings] states as follows.

However, in [7.2.2.12 system_set_sleep_parameters (SSLP, ID = 2/19)] of [7.2 API Commands and Responses], it is as follows.

Since the setting read from Module is also "L = 1", I think that the description of [7.2.2.12 system_set_sleep_parameters (SSLP, ID = 2/19)] is incorrect.

What do you think?

Best regards,

Takahashi

[Charles_Lai · Accepted solution]

Hi,

Yes you are right about it. It's confirmed that in the actual EZ-Serial firmware, the factory setting of SSLP mismatches with the user guide. Revision has been started, the firmware or the user guide would be corrected later.

Thanks for collecting the information.

Best regards