Apr 22, 2021
09:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 22, 2021
09:03 AM
Hello,
I am pretty new to Cypress boards. Is it possible to use bluekitchen/btstack with the CYW920819EVB-02 over UART? I see support for older boards but not this one.
Thanks.
Solved! Go to Solution.
Labels
1 Solution
Apr 26, 2021
01:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 26, 2021
01:50 AM
CYW20819 can support controller mode. You need to pull HCI UART CTS pin to high during the Power on or hardware reset procedure. Then you can send hci reset command through HCI UART. The device can accept all the standard HCI command.
1 Reply
Apr 26, 2021
01:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 26, 2021
01:50 AM
CYW20819 can support controller mode. You need to pull HCI UART CTS pin to high during the Power on or hardware reset procedure. Then you can send hci reset command through HCI UART. The device can accept all the standard HCI command.