I am pretty new to Cypress boards. Is it possible to use bluekitchen/btstack with the CYW920819EVB-02 over UART? I see support for older boards but not this one.
CYW20819 can support controller mode. You need to pull HCI UART CTS pin to high during the Power on or hardware reset procedure. Then you can send hci reset command through HCI UART. The device can accept all the standard HCI command.
CYW20819 can support controller mode. You need to pull HCI UART CTS pin to high during the Power on or hardware reset procedure. Then you can send hci reset command through HCI UART. The device can accept all the standard HCI command.
