CYBT 343026 maximum throughput when using EZ serial

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
SaEa_4705941
Level 3
Level 3
25 replies posted 10 replies posted 10 questions asked

What is the maximum throughput when using this module in BTclassic and 1M baudrate? Would that be the same as HCI mode?

It would be helpful if you could share any data related to throughput testing in using Ez serial.

Thanks,

Se

0 Likes
1 Solution
Owen_Zhang123
Moderator
Moderator
Moderator
5 questions asked 500 solutions authored 250 sign-ins

Per our internal test, the speed is 65 KBps from module to laptop  and 35 KBps from laptop to module with flow control enable and no data loss.

View solution in original post

3 Replies
Owen_Zhang123
Moderator
Moderator
Moderator
5 questions asked 500 solutions authored 250 sign-ins

Per our internal test, the speed is 65 KBps from module to laptop  and 35 KBps from laptop to module with flow control enable and no data loss.

Thanks XinghaoZ_26

Was it achieved with the hardware flow control or the software one?

Also, if I increase the baud rate, is that possible to achieve a throughput close to 100KBps from the module to laptop in Ezserial mode?

0 Likes

It is achieved with the hardware flow control by enable the flow control of PUART in the EZ-Serial FW.

The speed is limited by the data process and SPP transmission. Increase the UART baudrate will not help.

0 Likes