cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Studio Bluetooth

New Contributor II

I am using the CYBT 343026-01, the pin LP_MODE is pull down. The CYBT 343026-01 is not working at all.

By changing the LP_MODE to high, this is working well.

Why is it not working ?

Thank you for you quick answer

1 Solution
8 Replies
Moderator
Moderator

Could you check the sleep level setting GSLP? The level should be 1 which means "normal sleep when possible".

If you set it to 2, then you need to use the GPIO to wakeup the device. And it will reboot during the wakeup.

0 Likes
Reply
New Contributor II

XinghaoZ_26​ thanks for your answer.

I use the CYBT 343026-01 without any modification. Normally the default value from the factory should be ok.

At this time, I only have the UART communication between a STM32 and this module.

What can I do to solved this problem ? The board cannot be modified.

0 Likes
Reply
Moderator
Moderator

If the sleep level is set to 1, the device will go into sleep mode when it is possible. In the normal sleep mode, the UART will be shut down and all the command will not be recognized. The device can only wake up from the LP_Mode pin. Is this Pin connected with the MCU?

Do you need sleep mode in your application? If not, you can configure the sleep level to 0 to avoid the device go into sleep mode and save it to the flash during your production.

0 Likes
Reply
New Contributor II

The LP_mode pin is directly tied to GND and cannot be modifed.

How can I change the sleep level to 0 ? I have only uart connected to MCU.

0 Likes
Reply
Moderator
Moderator

I just checked internally, there is a updated version for the EZ-Serial. It can wake up the device by UART command.

Could you ask your local FAE/Marketing for test as it is not official released?

0 Likes
Reply
New Contributor II

I understand that the EZ serial is not working for my application.

I need to upload the new one (not official).

As I have buy the component to Digikey, I am not sure that they can provide it.

Could you provide it to me ? Do you have a contact to provide?

0 Likes
Reply
New Contributor II

Is there any special step to update it ?

How do we do ? Special pin must be linked ?

Thanks for your help.

0 Likes
Reply