Dec 13, 2020
10:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 13, 2020
10:37 AM
Hello,
I am using WICED Studio 6.2 with CYBT-343026-01 and I am using GPIO06 pin for reading input with pullup as the default state. But When I trying to check the status of GPIO06 it shows 0 continuously. it should be 1 when the button is not pressed. and I am expecting it should be 0 only If the button is pressed. Also, I have checked with GPIO 3 pin and it works perfectly.
Is there any limitation that I cannot use this GPIO6 pin as input?
Thanks and regards,
Neeraj
Solved! Go to Solution.
1 Solution
Dec 16, 2020
12:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 16, 2020
12:14 AM
Hi,
Instead of GPIO06 I have used P11 in function and it works for me.
Regards,
Neeraj Dhekale
1 Reply
Dec 16, 2020
12:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 16, 2020
12:14 AM
Hi,
Instead of GPIO06 I have used P11 in function and it works for me.
Regards,
Neeraj Dhekale