- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Please let me know the state of the "ALL PINS" during reset?
I know what UART pins was discussed below.
[CYBT-343026-01] Pin state during reset
I would like to know similar information about following.
1pin P0_P34
2pin I2C_SCL
4pin I2C_SDA
5pin P2_P37_P28
6pin SPI2_CS_N
8pin SPI2_MISO
9pin SPI2_MOSI
10pin SPI2_CLK
11pin GPIO_0
12pin GPIO_1
14pin GPIO_4
15pin P4/P24
19pin GPIO_7
22pin GPIO_3
23pin GPIO_6
Thanks
TM
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi mizukosi_1708256,
'During' reset, all pins will be in Hi-z state only. Just after reset, pins will behave as per the defined state in registers or application(if already programmed).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi mizukosi_1708256,
'During' reset, all pins will be in Hi-z state only. Just after reset, pins will behave as per the defined state in registers or application(if already programmed).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi SheetalJ_96
Thank you for your reply.
I got it.
Thanks
TM