- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I had one BCM920737TAG board, and I downloaded "wiced_sense-BCM920737TAG_Q32 download" into my board.
Then, the board trace port output like this continuously, why?
"
wiced_sense_battery_measurements_average = 2822
Battery: Level = 85
"
BTW, I have commented out all relative sensors like this:
// Whether to support the accelerometer
#define WICED_SENSE_SUPPORT_ACCEL 0
// Whether to support gyro or not.
#define WICED_SENSE_SUPPORT_GYRO 0
// Whether to support the humidity sensor
#define WICED_SENSE_SUPPORT_HUMIDITY 0
// Whether to support the magnetometer
#define WICED_SENSE_SUPPORT_MAGNETOMETER 0
// Whether to support the pressure sensor
#define WICED_SENSE_SUPPORT_PRESSURE 0
// Whether to support the temperature sensor
#define WICED_SENSE_SUPPORT_TEMPERATURE 0
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I spoke to the developers and these are just traces of the battery level.
Compiling in/out the sensor related code has no effect on battery level measurements.
It sounds like this is a non-issue.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I spoke to the developers and these are just traces of the battery level.
Compiling in/out the sensor related code has no effect on battery level measurements.
It sounds like this is a non-issue.