- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We use the BCM20736S and we found some strange behavior of GPIO P33:
We want/must to use this GPIO P33 as an ADC input.
After power on or reset everything is OK, but after wakeup from LPM this GPIO is set to output !!!
(see following trace logs)
What is the reason for this ?
How could we avoid this? Is there a software workaround?
We don't want to change our hardware PCB design (if possible)!
Trace (C-code):
UINT16 cfg1 = gpio_getPinConfig( 0, 4);
UINT16 cfg1a = gpio_getPinConfig( 0, 8);
UINT16 cfg2 = gpio_getPinConfig( 2, 0);
UINT16 cfg2a = gpio_getPinConfig( 2, 1);
ble_trace2("cfg1:%02x cfg1a:%02x", cfg1, cfg1a);
ble_trace2("cfg2:%02x cfg2a:%02x", cfg2, cfg2a);
After PwrOn/Reset:
12:45:00 - CreateFnc
12:45:00 - cfg1:600 cfg1a:600
12:45:00 - cfg2:600 cfg2a:600
12:45:00 - SetLpm
12:45:00 - cfg1:0b cfg1a:600
12:45:00 - cfg2:0b cfg2a:600
12:45:00 - Entering Lpm.
After wakeup:
12:46:11 - CreateFnc
12:46:11 - cfg1:0b cfg1a:600
12:46:11 - cfg2:0b cfg2a:4600 // why is this GPIO P33 now set to output ??? !!!
- Labels:
-
ADC
-
GPIO
-
Sleep Modes
- Tags:
- gpio p33