- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
We can't use the chipload binaries as our manufacturing computers run on ARM.
- Would it be possible to get the source-code of chipload?
or
- is the UART protocol for the bootloader documented somewhere?
or
- are there any other existing tools or implementations (like openocd) out there that can be used that doesn't rely on chipload
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi DaEr_349131,
1. Unfortunately, source code of Chipload is not available for customers.
2. Do you mean the sequence of HCI commands to program the board? Please elaborate. You can refer /doc/WICED-HCI-Control-Protocol.pdf.
3. Apart from WICED SDK, you can use CyBluetool (Windows Installer) or ClientControl.exe available in WICED SDK for programming the board.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi DaEr_349131,
1. Unfortunately, source code of Chipload is not available for customers.
2. Do you mean the sequence of HCI commands to program the board? Please elaborate. You can refer /doc/WICED-HCI-Control-Protocol.pdf.
3. Apart from WICED SDK, you can use CyBluetool (Windows Installer) or ClientControl.exe available in WICED SDK for programming the board.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1. Please consider it to allow running this from Linux running on ARM.
2. Thanks, doable.
3. We need to run our own software, so no window or .exe's can be used.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately, we can't provide the source code for the same.