Smart Bluetooth Forum Discussions
Hi,
Are there any conditions when bleappfwu_watchdogExpired(0) should *NOT* be used?
For instance, is it OK to commence bleappfwu_watchdogExpired(0) at the following timing?
- DeepSleep
- Advertising
- Connecting
- Upon the reception of Write request
Show LessHi,
I'm using a BCM92073X_LE_KIT, connected to WICED SDK, it has been working fine for the past few months, however today it has stopped working.
Nothing can be seen through the UART terminals.
When we try to upload a program to the tag it says no device detected, even after following all procedures outlined in the WICED Smart™ Development System Quick Start Guide. (i.e. Appendix 😧 Recovering a Corrupt WICED Smart Tag).
It seems as though the tag may be unrecoverable...
Has anyone had a similar issue? Is there any other way to recover it?
Show LessHi all,
RH readings from wiced sense 2 using the official android app seems to be 15 to 20 units (RH %) higher than real RH.
Also the RH reading is not updated (waited 10 min) ; is updated only when I disconnect and reconnect.
The temperature is updated quite often, it seems OK.
Has anybody noticed the same?
Thank you for reading.
Adrian Fabry
Show LessIs there anyone can give me some simple demo for 20737.Such as ledblink. Just this function.Anything else should be delete.As simple as it can be .
If there is ,thanks!
my mail adrress : 13523698526@163.com
Show LessDear Cypress team,
In the data sheet of CYW20719, there is "Maximum input : -20dBm" in Receiver RF Specifications.
Would you please let me know what happens on IC if there is over than -20dBm input?
I would like to know if -20dBm is maximum values of LNA inside of IC and if IC get permanent damage when over than -20dBm RF signal is entered.
Regards,
Ryan
Show LessDear Cypress team,
In the data sheet of CYW20719, it support typical +4dBm output power.
I have below two question about Tx of 20719.
1. Can I modify output power using WiCED Studio?
2. Does 20719 support external PA?
Regards,
Ryan
Show LessHi,
Can I disable the BCM20706's BT and only use BLE connection device in standby mode ,and when BLE received the instructions to transmit audio then open the BT connection, and transmit audio?
This is used to save power.
Thanks.
Randy.
Show Less
All the guages on my Wiced Sense IOS App work correctly but temperature and humidity do not change when
the tag is exposed to tempeature and humidity fluctuations. Are there any know n issues? Not sure about the pressure
gauge as this should be stable.
Show Lesswe found that WICED 4.1.0.43 ble_keyboard couldn't reconnect with IOS 10.2.
As we know IOS 10.2 support Secure connection.
What need to config that 20735 BLE keyboard could reconnect IOS device and could receive the BLE notification
Show LessHello !
I just bought 2 wiced-sense units and testing then with the android application (updated both to 1.3 detected and done on the first run) one of then do not show compass information properly the values only vary between 120 and 170 degrees.
There is warrant for this products ?
How it can be replaced/fixed ?
Cheers !
Show Less