Anonymous
Not applicable
Dec 08, 2014
11:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 08, 2014
11:34 AM
Whether the iOS WICED sense program uses SPI or I2C for comm to the SM sensors. How to swap between the 2, is there any code change required?
Solved! Go to Solution.
1 Solution
Dec 09, 2014
09:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 09, 2014
09:37 PM
3 Replies
Anonymous
Not applicable
Dec 08, 2014
11:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 08, 2014
11:43 AM
Kevin,
The Sensor are I2C based.
Thanks
JT
Dec 08, 2014
03:26 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 08, 2014
03:26 PM
JT thanks...the sensors require I2C.
If the sensors required SPI, the BCM20737S would support SPI, correct?
KJ.
Dec 09, 2014
09:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 09, 2014
09:37 PM
Yes, 20737S supports SPI, not only in master but also in slave.