Anonymous
Not applicable
Aug 12, 2015
02:44 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 12, 2015
02:44 PM
Hi,
I am using BCM920737TAG-03 to send some data over puart to a sensor? I need to connect the ground of the boards together, where is the ground pin of the tag 3?
Also for puart, should I use P32 and P33 from GPIO pins on the board? then should all the switches on SW4 be on?
or
should I change SW4 switches (which one?) and use the pins on JP1 for puart?
Thank you.
Solved! Go to Solution.
Labels
- Labels:
-
Peripherhal UART
1 Solution
Anonymous
Not applicable
Aug 12, 2015
03:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 12, 2015
03:46 PM
Hello Danial,
Please see this post: Hardware User Guide (SDK 2.x and TAG3 Board)
The Schematics show the I2C Header J9 Pin 4 as a GND.
Hope this helps
JT
1 Reply
Anonymous
Not applicable
Aug 12, 2015
03:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 12, 2015
03:46 PM
Hello Danial,
Please see this post: Hardware User Guide (SDK 2.x and TAG3 Board)
The Schematics show the I2C Header J9 Pin 4 as a GND.
Hope this helps
JT