Set_Tx_Carrier_Frequency_ARM for CYW43455

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
AnCh_3708191
Level 1
Level 1

I am trying to implement some RF test software so I can send my product to a test house.  I need to be able to generate a continuous frequency at differing powers and modulation.  The Set_Tx_Carrier_Frequency_ARM command seems to be ideal for my needs, but it doesn't work.  Can anyone tell me the correct command sequence I should be sending using hcitool?

This is running on a headless Raspberry Pi CM3 so no way of using any GUI based packages, just the commandline.

0 Likes
1 Solution
AnjanaM_61
Moderator
Moderator
Moderator
5 comments on KBA First comment on KBA 5 questions asked

Hi AnCh_3708191 ,

Please have a look at the commands here: HCI-Based Bluetooth Testing

Make sure you get a success response for HCI reset command first at the start.

Regards,

Anjana

View solution in original post

1 Reply
AnjanaM_61
Moderator
Moderator
Moderator
5 comments on KBA First comment on KBA 5 questions asked

Hi AnCh_3708191 ,

Please have a look at the commands here: HCI-Based Bluetooth Testing

Make sure you get a success response for HCI reset command first at the start.

Regards,

Anjana