Attachments are accessible only for community members.
Nov 11, 2017
01:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 11, 2017
01:36 PM
Random OTA transfer Freeze | |
Hello, I could able to perform OTA transfer for 20736 chipset. But there is random freeze in transfer. But whenever , the transfer is through OTA is successful. Setup: - using WsOtaUpgrade.exe - Satechi USB 4.0 Bluetooth Adapter [BCM20XXX] - Generated ota bin file. Scenario: - Perform Fresh down load of initial version software 0.6 - Initiate ota transfer from PC version 0.7 - First transfer happens properly. - Again after Reset, revert back to 0.6 thourgh OTA. This goes fine. - Then, subsequent ota trasnfer creates random freeze in between transfer. - The sequence was repeated again and again with reset to target hardware. After 10 reset and restart the ota goes through complete sucessfully. - then all subssequent ota transfer are with freeze.at random point of transnfer. Attached debug message from both cases. |
Solved! Go to Solution.
Labels
- Labels:
-
Over The Air Upgrades - OTA
1 Solution
Nov 16, 2017
03:57 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 16, 2017
03:57 PM
Thanks for your valuable support.
Found issue; we need to disable "Allow the computer to turn off this device to save power" in ‘Power Management’ for dongle.
I referred follwing Re: Why error occur when I open WsOtaUpgrade.exe?
Now can perform OTA for mor ethan 8 times , by switching between version without glitch.
I also retaitned the PAtCH in make file.
THanks again
haric
8 Replies